代码: 全选
OpenBSD IEEE 1275 Bootblock 1.3
..>> OpenBSD BOOT 1.6
Trying bsd...
Booting /pci@7c0/pci@0/pci@8/scsi@2/disk@0,0:a/bsd
8095864@0x1000000+6024@0x17b8878+202744@0x1800000+3991560@0x18317f8
symbols @ 0xfef22400 176+453264+293973 start=0x1000000
[ using 748440 bytes of bsd ELF symbol table ]
console is /virtual-devices@100/console@1
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2014 OpenBSD. All rights reserved. http://www.OpenBSD.org
OpenBSD 5.5 (GENERIC.MP) #173: Tue Mar 4 14:47:47 MST 2014
[email protected]:/usr/src/sys/arch/sparc64/compile/GENERIC.MP
real mem = 8581545984 (8184MB)
avail mem = 8429682688 (8039MB)
mainbus0 at root: Sun Fire(TM) T1000
cpu0 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu1 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu2 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu3 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu4 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu5 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu6 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu7 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu8 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu9 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu10 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu11 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu12 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu13 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu14 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu15 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu16 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu17 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu18 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu19 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu20 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu21 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu22 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
cpu23 at mainbus0: SUNW,UltraSPARC-T1 (rev 0.0) @ 1000 MHz
vbus0 at mainbus0
"nvram" at vbus0 not configured
vcons0 at vbus0: ivec 0x111, console
"ncp" at vbus0 not configured
vrtc0 at vbus0
"loop" at vbus0 not configured
"loop" at vbus0 not configured
"echo" at vbus0 not configured
"fma" at vbus0 not configured
"sunvts" at vbus0 not configured
"sunmc" at vbus0 not configured
"explorer" at vbus0 not configured
"led" at vbus0 not configured
"flashupdate" at vbus0 not configured
"flashprom" at vbus0 not configured
vpci0 at mainbus0: bus 2 to 2, dvma map 80000000-ffffffff
pci0 at vpci0
vpci1 at mainbus0: bus 2 to 4, dvma map 80000000-ffffffff
pci1 at vpci1
ppb0 at pci1 dev 0 function 0 "ServerWorks PCIE-PCIX" rev 0xb3
pci2 at ppb0 bus 3
bge0 at pci2 dev 4 function 0 "Broadcom BCM5714" rev 0xa2, BCM5715 A1 (0x9001): ivec 0x7d4, address 00:14:4f:22:07:e4
brgphy0 at bge0 phy 1: BCM5714 10/100/1000baseT/SX PHY, rev. 0
bge1 at pci2 dev 4 function 1 "Broadcom BCM5714" rev 0xa2, BCM5715 A1 (0x9001): ivec 0x7d5, address 00:14:4f:22:07:e5
brgphy1 at bge1 phy 1: BCM5714 10/100/1000baseT/SX PHY, rev. 0
ppb1 at pci2 dev 8 function 0 "ServerWorks HT-1000 PCIX" rev 0xb3
pci3 at ppb1 bus 4
bge2 at pci3 dev 1 function 0 "Broadcom BCM5704C" rev 0x10, BCM5704 B0 (0x2100): ivec 0x7c2, address 00:14:4f:22:07:e6
brgphy2 at bge2 phy 1: BCM5704 10/100/1000baseT PHY, rev. 0
bge3 at pci3 dev 1 function 1 "Broadcom BCM5704C" rev 0x10, BCM5704 B0 (0x2100): ivec 0x7c1, address 00:14:4f:22:07:e7
brgphy3 at bge3 phy 1: BCM5704 10/100/1000baseT PHY, rev. 0
mpi0 at pci3 dev 2 function 0 "Symbios Logic SAS1064" rev 0x02: msi
scsibus0 at mpi0: 63 targets
sd0 at scsibus0 targ 0 lun 0: <ATA, HITACHI HDS7216S, AB8A> SCSI3 0/direct fixed naa.5000cca321ca5f01
sd0: 152627MB, 512 bytes/sector, 312581808 sectors
ebus0 at mainbus0
com0 at ebus0 addr c2c000-c2c007 ivec 0xa: st16650, 32 byte fifo
vscsi0 at root
scsibus1 at vscsi0: 256 targets
softraid0 at root
scsibus2 at softraid0: 256 targets
bootpath: /pci@7c0,0/pci@0,0/pci@8,0/scsi@2,0/disk@0,0
root on sd0a (988668a817450466.a) swap on sd0b dump on sd0b
Automatic boot in progress: starting file system checks.
/dev/sd0a (988668a817450466.a): file system is clean; not checking
/dev/sd0k (988668a817450466.k): file system is clean; not checking
/dev/sd0d (988668a817450466.d): file system is clean; not checking
/dev/sd0f (988668a817450466.f): file system is clean; not checking
/dev/sd0g (988668a817450466.g): file system is clean; not checking
/dev/sd0h (988668a817450466.h): file system is clean; not checking
/dev/sd0j (988668a817450466.j): file system is clean; not checking
/dev/sd0i (988668a817450466.i): file system is clean; not checking
/dev/sd0e (988668a817450466.e): file system is clean; not checking
setting tty flags
pf enabled
starting network
starting early daemons: syslogd pflogd.
starting RPC daemons:.
savecore: no core dump
checking quotas: done.
clearing /tmp
starting pre-securelevel daemons:.
setting kernel security level: kern.securelevel: 0 -> 1
creating runtime link editor directory cache.
preserving editor files.
starting network daemons: sshd sendmail sndiod.
starting local daemons: cron.
Sun Jun 29 11:09:35 CST 2014
OpenBSD/sparc64 (openbsd.lmg.com.cn) (console)
login:
